This is the main timing reference for HackLab.TO (and tick.hacklab.to).

Project Overview

Built into an American Data 800-series chassis (3U, 10 modules each with line voltage on an edge connector + space for a connector to the back panel)
Chassis came with 10 AD805 distribution amplifiers (1 BNC in, 1 daisychain out, 6 amplified outputs)
- Will replace as many as required with other timing-related modules, remaining ones will be used to distribute timing references around

GPS Module

Will take up 2 slots
Motorola OnCore UT timing receiver
7-segment LED displays for:
- UTC Time (6 digits, red)
- Number of SVs in view (2 digits, green)
LEDs
- Power (green)
- Comms (white)
- GPS Fix (blue)
- Replace Battery (yellow)
- Fault (red)

2013-11: Received and assembled, GPS communication works but GPS never locks. Need to troubleshoot this further, could be a setup issue, bad GPS board, or an issue with the RF pass-through.
2013-10-14: Main board sent to OSH Park for prototype. Display board will be done later.
2013-05-16: Main board checklisted, ready for CAM. Display board schematicized, routed. Needs to have mechanical design done and be checklisted.
2013-05-15: Main board completely laid out, just needs checklist run.
2013-05-13: Chassis is here now and has no PSU, just line voltage going to the cards. Redesigned the module to have a main board (which has the AC/DC converter and most logic on it) and a display board (which has the LED driver and displays on it, and goes on the front panel). Main board is schematicized and 50% laid out now.
2013-Early: Designed the module to go on the back of the front panel.