StrichLux/IO-DMX

From Hackstrich
Revision as of 15:08, 2 May 2012 by SarahEmm (talk | contribs) (JTAG worked on.)

The StrichLux IO-DMX module will provide one universe of DMX for the StrichLux system, and can be used as either an input module or an output module.

Project Status

  • 2012-05-01: Still not able to get it working on real hardware. Attempted to get JTAG working, found TDI/TDO pins were connected wrong, green-wired it and can now connect to the chip via JTAG. Will do more troubleshooting tomorrow.
  • 2012-04-29: Spent a few hours finding/fixing bugs, simulator now looks really good. Will test on real hardware this week.
  • 2012-04-23: Worked more on the code for the CPLD, it's getting stuck somewhere in the state machine and hanging outputting a high level. Need to troubleshoot more in the simulator.
  • 2012-04-20: Programmed CPLD and it successfully blinks the status LED green/red! Also started working on the controller code.
  • 2012-04-10 - 2012-04-20: Wrote Ruby code to read JEDEC files (ruby-jedec) and program MachXO2 CPLDs via the Bus Pirate
  • 2012-04-04: Wishbone interface for DMX transmitter complete, as is mux for sharing the bus between SPI and DMX. Controller is the last Verilog piece pending.
  • 2012-04-03: Verilog for DMX transmitter complete and tested in simulator.
  • 2012-03-17: Schematic complete and checklist checked, starting and finished board layout/routing, CAM done, submitted to Laen for PCB manufacturing. Parts still need to be ordered.
  • 2012-03-15: BOM is complete, schematic almost complete.
  • 2012-03-14: Started schematizing/putting BOM together.

Specs

  • One universe of DMX, no RDM support at least at the beginning.
  • Can be used as an input or output module.
  • Based around the Lattice MachXO2-256 CPLD

Rev. 1 Issues

  • TDI/TDO signals are not connected to the right pins

Architecture

<graph>graph {output: svg;}[ SPI Hardcore ] <-- Wishbone --> [ Module Supervisor Softcore ] <-- Wishbone --> [ DMX Softcore ]</graph>

Logic

  • State INIT
    • Send READ command to Core Board w/ address 0
    • Enable DMX Transmission
    • State change to DMXWAIT
  • State DMXWAIT
    • Wait for DMX "ready for channel data" interrupt
  • State SPIREAD
    • Read 1 byte of data from Core Board
    • Send 1 byte of data to DMX output via Wishbone
    • Increment channel counter
    • State change to DMXWAIT if counter == 511
    • State change to IPDWAIT if not
  • State IPDWAIT
    • Wait for inter-packet delay time
    • State change to INIT