Difference between revisions of "StrichSwitcher"

From Hackstrich
(Putting up initial page for the strichSwitcher.)
 
(There are a bunch of other similar products on the market now, so cancelling this project.)
 
(6 intermediate revisions by the same user not shown)
Line 2: Line 2:
  
 
== Project Status ==
 
== Project Status ==
Schematic/board done, BOM on file at Digikey, board sent to BatchPCB for prototype manufacturing.
+
Schematic/board done, rev. 1 PCBs received from BatchPCB and parts received from Digikey.  Initial order from Digikey shipped resistors instead of caps (330ohm instead of 330pF!), I didn't notice stuffing the board, and something let the magic smoke out (I think the main controller chip).  Replacement chip and caps received from Digikey.
  
 
== Design Overview/Ideas ==
 
== Design Overview/Ideas ==
Line 8: Line 8:
 
* Buck/boost topology to support battery inputs
 
* Buck/boost topology to support battery inputs
  
[[Category:Current Projects]]
+
[[Category:Cancelled Projects]]

Latest revision as of 00:34, 23 January 2012

strichSwitcher is a small integrated switching regulator, designed to take 2.8-7V (i.e. battery inputs from standard AA/C/D cells or LiIon/LiPoly cells) and output 5 or 3.3V.

Project Status

Schematic/board done, rev. 1 PCBs received from BatchPCB and parts received from Digikey. Initial order from Digikey shipped resistors instead of caps (330ohm instead of 330pF!), I didn't notice stuffing the board, and something let the magic smoke out (I think the main controller chip). Replacement chip and caps received from Digikey.

Design Overview/Ideas

  • Based around the LTC3534 switching controller
  • Buck/boost topology to support battery inputs