Search results

Create the page "Time" on this wiki! See also the search results found.

• FLCBeacon
  ...be made of mostly off-the-shelf parts plugged together, as I have limited time to get it put together. ...to each strip, to save power when nothing is displayed and during the day time
  3 KB (554 words) - 20:55, 9 May 2024
• VGA Shield
  ...alling this completed, Rev3 boards are working and have been sold for some time, if I get around to building the integrated version I'll start it as a new ...to Waiting for Time. Rev 2 boards did not arrive (postal system fail) in time, so rev. 3 will be designed and sent out for production boards, without hav
  5 KB (916 words) - 15:04, 1 March 2017
• Continuity Tester
  * Lasts a long time on a CR2032 or similar
  4 KB (685 words) - 17:38, 30 March 2018
• BlinkieBits
  * It may take too much CPU time/code (especially on small CPUs) to keep up with the BlinkieNet (on a large * Will forwarding BlinkieNet packets through every node in the matrix be too time-consuming for decent frame rates? If so, do we need to connect the whole m
  6 KB (933 words) - 03:28, 25 November 2012
• MultiSerial Shield
  ...information from a whole network of BlinkieBits, rather than just one at a time.
  7 KB (1,111 words) - 20:47, 27 December 2011
• StackClock
  ...nch more, now keeps (sort of, it starts at a fixed point and can't be set) time! Numeric display still getting corrupted for 1-2 seconds randomly, need to ...k up to make this, failed to find anything nice looking that supported 24h time. The [http://incolor.inebraska.com/bill_r/hayes_stack_chronograph.htm Hayes
  12 KB (2,000 words) - 02:07, 12 January 2019
• Project Dandelion/Power System
  |Real Time Clock frequency reference - 120V side |Real Time Clock frequency reference - 12V side
  642 bytes (108 words) - 13:25, 4 April 2010
• Coduino
  ...status, as I won't have time until after Burning Man as I'm putting all my time into [[Beacon4]]. * 2012-04: Boards are here, awaiting time to test.
  2 KB (389 words) - 14:15, 2 June 2013
• Beacon2
  * Charging chip did not arrive in time, so the charge controller was bypassed and the solar cell connected straigh ...ogram 0 should run for less time. No more than 5 seconds at a time. Blank time makes it too hard to locate the beacon.
  8 KB (1,359 words) - 19:00, 11 August 2011
• Beacon3-OriginalPlans
  ....pde#L153 Program 0] should run for less time. No more than 5 seconds at a time. ...tra-board comms would work (as long as the ATwhatever has both at the same time supported)
  2 KB (403 words) - 13:01, 19 July 2011
• PoE Shield
  ...main in a 'halt state' until the UVLO threshold has been reached, at which time it will connect VEE to RTN (via an internal power MOSFET) which will start
  15 KB (2,569 words) - 04:57, 26 December 2012
• Solder Paste Dispenser
  ...or has been working fine for now. System works great and saves us a lot of time! ...tSpark board successfully. System worked great and saved a huge amount of time. Still need to get the small tank working and find the bezel for the back
  2 KB (303 words) - 19:19, 10 November 2013
• Project Pipeline
  === Waiting for Free Time === |category=Status/Waiting for Time
  1,003 bytes (131 words) - 11:03, 19 October 2010
• Anchor
  * 2011-10-21: Brought up board and programmed it for the first time, found issue with TFT FPC connector (worked around) and backlight driver (w
  7 KB (1,143 words) - 16:57, 29 January 2012
• HackTrack
  HackTrack is going to be a system to keep track of who's been spending time cleaning the lab ([http://www.hacklab.to HackLab.TO]) and award points and ** Will do one more test next time, then counterbore the final panel
  3 KB (550 words) - 15:05, 1 March 2017
• Beacon3
  ...(less?) pole for Burning Man 2011. It will be simpler than [[Beacon2]] as time is limited to get it done, but we want a brighter beacon. ...not 2 as I thought). Wrote "health check" code (run each emitter one at a time at 200mA, checking the status register while it's on to see if there are an
  8 KB (1,253 words) - 03:26, 25 November 2012
• IOstrich
  * 2011-10-18: First board assembled, but no time to test today.
  2 KB (356 words) - 03:01, 30 January 2012
• TileDriver
  ...em right. Ran out of time after this point, need to pick back up here next time. Wrote a quick 'tilegradient' tool to generate a 0-255 gradient for trouble
  3 KB (522 words) - 15:15, 28 March 2021
• BRCRD Scoreboard
  ** 1x JT remote will have jam start/stop button and a time/status display in case the operator can't see the scoreboard
  2 KB (321 words) - 14:50, 13 June 2016
• HackLab.TO Bandwidth Display
  ...ant to put a proper gel over the displays but it looks pretty good for the time being as-is. Done other than that!
  5 KB (846 words) - 01:08, 10 April 2015
• HackLab.TO Timing Reference A
  ** UTC Time (6 digits, red)
  3 KB (433 words) - 14:03, 13 November 2017
• EL Driver 1
  ...mostly, but there's a weird short pulse right before it goes into the off-time. Attempted to test, but since the HVDC side isn't generating enough voltag ...the diode in the snubber with a Schottky on Tuesday to avoid the response time associated with p-n diodes, see if that fixes it.
  4 KB (742 words) - 04:53, 26 December 2012
• StrichLux
  ...nnectorized the rest of the channels, tests successful on one channel at a time. Still only have one [[StrichLux/IO-SPI|IO-SPI]] module built, so can't te ...ould allow multi-channel fanout mode via TAKEOVER command. Will test next time I'm at the lab.
  8 KB (1,178 words) - 06:46, 30 December 2014
• Skating Lap Counter
  * 2015-09-12: Putting this on the back burner since I don't have time for it and have been off-skates injured for 6 months now anyways.
  2 KB (252 words) - 18:28, 12 September 2015
• Huxley
  * 2012-06: Dormant until post-burn as all my time is going into [[Beacon4]]. ...d and installed Sprinter on it. ReplicatorG recognizes it, but ran out of time to test it with motors.
  4 KB (639 words) - 14:04, 13 November 2017
• Beacon4
  ...ArtnetForProcessing instead of LightJams, and had no software issues this time. ...BRC than I would have liked, need to emphasize quick setup time more next time
  33 KB (4,431 words) - 00:23, 27 September 2013
• StrichLux/IO-SPI
  ...ixed/working in the simulator. Need to re-test against real hardware next time I'm at the lab.
  4 KB (630 words) - 00:56, 5 September 2023
• StrichLux/IO-ETH
  ...ully discovers the node. Hardware investigation will have to be done next time I'm at the lab. * 2012-06-21: PCBs and parts are here, assembled the first board. No time to test, will have to do that tomorrow. Firmware is ~10% complete.
  3 KB (534 words) - 06:45, 30 December 2014
• Zappy Module
  ...so the wrong value on BOM, so need to fix that to get proper feedback next time and see how it looks after doing that. ...riggering but really need the logic on the board to test it properly. Next time will assemble logic and throw some test firmware together to sequence charg
  8 KB (1,421 words) - 14:06, 13 November 2017
• ECLair
  ...8-bit binary decoder (MC10H161) drives their reset pins to allow one at a time to drive the bus. Still passes tests at up to 33MHz (30ns clock) which is g ...tionality, was testing at the wrong moment and also skipping tests at HALT time. Both fixed now, and sub8.ab passes all tests (was failing ~60% before).
  23 KB (3,832 words) - 17:43, 5 May 2018
• Playameter
  * 2012-09-09: Dormant until I have more time to work on this with Lisa, hopefully before BM2013.
  1 KB (219 words) - 05:08, 9 September 2012
• SafeCode
  ...tring has replaced my need for this, calling it cancelled at least for the time being. ....io is a thing now and works great, so less need for this at least for the time being. Dormantizing.
  6 KB (905 words) - 02:43, 14 June 2015
• HackLab.TO Rb Frequency Reference
  ...ce the scales, as I'd hoped. Scales created in Meter, ready to apply next time I'm at the lab.
  2 KB (264 words) - 21:20, 14 October 2013
• DMXKitty
  ...en done, checklist run, sent to OSH Park w/ Priority shipping to get it in time for this month's hackoff. Also ordered PoE modules from Silvertel/Semicond ...e if there's anywhere else we can use R/C packs to save component stuffing time</s> - Updated LEDs to use a 4x array in Rev002
  5 KB (937 words) - 13:31, 15 October 2014
• MeterBoard/CPUE
  * 2017-11: Has been running for a long time, calling this completed. Would like to clean up the firmware/make it more c
  2 KB (307 words) - 14:10, 13 November 2017
• Talking Darkroom Timer
  * The timer may ask if you want to adjust the time for specific steps.
  2 KB (362 words) - 00:14, 26 February 2017
• LaserBox
  ...an attach the tool to a running LaserBox and all changes are shown in real-time.
  6 KB (978 words) - 14:05, 13 November 2017
• LaserBox/Formats and Protocols
  ...directory, there are numbered pattern files that are chosen randomly each time ** 0x01 - Delay - Wait a certain amount of time before continuing on.
  3 KB (447 words) - 22:56, 16 April 2017
• Tether
  ...n one or both portable units go into/out of base station range. Re-syncing time slots when just the RX unit leaves and comes back seems to be the hardest p ** Keeps track of accurate time and gives time updates to nearby RX/TX units
  7 KB (1,114 words) - 21:29, 14 April 2018
• Nest ePaper Signage
  * Able to run on battery power for 1 month or more at a time ...sign is a 2.9" display, with one copy upstairs where we spend a lot of our time, and one copy downstairs by the front door. This sign is split in half, the
  19 KB (3,277 words) - 21:00, 24 October 2020
• Bluetooth Minidisc Remote
  * 2023-03-21: Stencil and PCBs arrived back in October/November, then had no time to work on anything. Parts all ordered, display has arrived from Mouser and ...est points. Still need to run the checklist on the schematic, then will be time to start drawing footprints for a few parts that don't have them yet.
  7 KB (1,275 words) - 14:41, 21 March 2024